1. Home
  2. OnLogic Systems
  3. Rugged Line
  4. POC-200 Technical Resources

POC-200 Technical Resources

POC-200 Drivers and Manual

POC-200 Motherboard Manual

https://drive.google.com/file/d/1kM7QWXBpIBUIMY1t1JT6Mq7rrBHeRZYc/view

POC-200 Drivers

https://drive.google.com/drive/folders/1hPF6L2nVz_Hkrx1VD8-RovlMjkfItY8Q

How to Enable Auto Power On

The POC-200 can be configured to turn on automatically. This is useful for power outage recovery or if the unit is mounted in a hard to reach location. You can enable Auto Power On by following the steps listed below:

  1. Power on the system and immediately press the F2 key a few times to access the BIOS.
  2. Navigate over to the Power tab.
  3. Change the option [Power On after Power Failure] to [S0 – Power on].
  4. Navigate to the Exit tab and choose “Save Changes and Reset”

POC-200 Hardware Troubleshooting

Opening the POC-200 does not void the manufacturer’s warranty. However, some precautions are necessary to avoid damaging the unit:

  • Perform this disassembly in an area free of static discharge
  • Before beginning, touch a grounded metal surface to discharge your body of static electricity

Opening the POC-200 Case

  1. Unscrew 4x hex bolts on the top of the heatsink.
  2. Unscrew 1x hex bolt from the side.
  1. Unscrew four M3 F-head screws on the bottom side.
  1. Slide the bottom cover off.
  1. Pull the HDD out of its slot and remove the tray.

How to Clear CMOS

  1. Remove the RAM by pressing outward on the two metal clips.
  2. The module will pop up to a 45 degree angle and can be removed straight out of slot.
  1. Locate the CMOS battery.

4. Remove the CMOS battery from the holder.
5. Wait 5 minutes.
6. Reinstall the battery. The CMOS is now clear.
7. Follow the instructions in reverse order to reassemble the unit.

Updated on June 23, 2020

Was this article helpful?

Related Articles

Need Additional Support?
Can’t find the answer you’re looking for? Don’t worry, we’re here to help!
Contact Support