1. Home
  2. TM610 (MC610-50) DC jack installation

TM610 (MC610-50) DC jack installation

  • Begin by removing the top 2 screws from the back of the unit.
  • Slide the lid off towards the back
  • Use a screwdriver to push out the two knockouts shown
  • Grab the knockouts with pliers and twist to remove
  • final result shown
  • Connect the 4 pin plug to the motherboard. It only fits 1 way. Push down gently until it clicks in.
  • Remove the nut and washer from the DC jack.
  • Push the DC jack through the larger of the 2 holes.
  • Install the washer and then the nut onto the DC jack from the outside of the case.
  • Hand tighten.
  • Slide the lid back on and reinstall the two screws
  • Grab the retaining zip tie kit
  • Push the zip tie into the hole
  • Face the ribbed side upward
  • Attach the clip to the power supply’s cable
  • Thread the zip tie through the clip’s hole and snug into place.
  • Use only the newly installed DC barrel jack to power the unit.
  • NEVER connect both power connectors at once.
Updated on December 14, 2021

Was this article helpful?

Need Additional Support?
Can’t find the answer you’re looking for? Don’t worry, we’re here to help!
Contact Support